Welcome Shenyang packaging materials Co. Ltd.
/ En
15940144708

News is not an event, news is an attitude.

Enterprise diaryCompany dynamics

Innovative ideas, constantly adjust the structure to cluster development to market orientation

Conditions, methods and precautions for the use of gas phase antirust membrane

Release time:2017-12-05 | Publisher:admin | Browse times:6860

Use conditions and use methods of gas phase antirust products

 

The gas phase antirust and rust proof film produced by Shenyang rust prevention and development is widely used in metal metallurgy, automobile and accessories, electronic equipment, military equipment and other industries. The common methods of use, conditions of use and attention in use of the gas phase antirust membrane are summarized as follows:

 


Conditions for the use of gas phase antirust membrane

 

1. metal products should be cleaned and dried according to the requirements of antirust packaging before gas phase rust proof packaging, so as to prevent rust in earlier stage due to corrosive media such as moisture, dust and chemicals.

2. phase antirust plastic film should be under 60 centigrade and the relative humidity should be controlled below 85% and near neutral (pH =6 - 8).


The method of using gas phase antirust membrane

 

1. select a specific type of rust proof film according to the metal material, and do not use it.

2. to distinguish between the antirust surface and the non antirust surface.

3., open the packaging of the sealed package. For the rust proof film bag, metal can be put in the bag, and the sheet will be packed with the side of the gas inhibitor to the metal.

4. try to drain the air in the packing and seal the packing. It is suggested that the thermal seal be adopted. During heat sealing, attention is paid to sealing temperature so that the sealing is strong and the deformation will not affect the use.

5 at the end of the other outer packing.

 
Precautions

 

1. to determine the material of the packed metal and to select the corresponding antirust film for different black metals and multi metals.

2. in the use of the attention to the distinction between rust and non rust surface, to make the surface of the surface of the metal to use.

3. rust proof metal surface and rust proof film should not be more than 300 millimeter.

4. the air in the packing space is as small as possible.

5. when the structure of the package is complex and the metal type is large and the volume is large, the design of comprehensive antirust packaging should be considered.

6. corrosion inhibitor surface and air contact time should not be more than 4 hours when the weather antirust membrane is used in the open package.

7. use gloves in the process of packaging and use to prevent sweat.

8., when packing metal products, such as being in a hot state, to avoid heat loss, decomposition or film deformation and damage, they should be cooled to near room temperature before packing.

9. antirust membrane should be operated as soon as possible to reduce the loss of effective components when it is used in opening and two cutting and welding.

10., when using the rust proof film to do the actual rust proof packaging, if the product has a raised part or sharp corner will damage the product, it should be wrapped or cushioned and other cushioning materials to protect it.

 
Shenyang antirust provides customers with a full process system anti rust solution, in the rust prevention case, from product cleaning to packaging protection, providing one-stop service support.

 

 

 

This article is Shenyang antirust original, reprinted please note. (picture for Shenyang antirust case)

 

The last one:Is the most expensive engine on the car? It's wrong to think so!Next article:China's steel demand in 2018 increased by 0.7% year on year

Return>>